For this part of the project you need 2 extension cords, two lamp holders for pendants with a built in switch, and two lamp shades.
Step 1 - "piggy back" extension cords
I bought two 5m "piggy back" extension cords from Bunnings. 5m seems quite long but the next option down is 3m which is to short. I also recommend the "piggy back" version as it means you don't use up all the plug points in your room, because the "piggy back" fitting has a plug on one side, and a plug point on the other.
Step 2 - attach the lamp holders
Next, cut off the socket end of the extension cord. The lamp holders are going to be attached to this end BUT you need to thread it through the holes in the cross piece before putting it on. Hold it up against the wall to make sure you have threaded it the right way. Attaching the lamp holder is as easy as changing a plug. You can see a close up of this type of fitting here.
For safety I am not going to explain how, ask your local hardware if you need help.
Step 3 - attach lamps to the wall
You will need to drill two holes (you can see them clearly on the left below) in the wooden upright that you are going to attach to the wall. I used a countersink drill piece so that the screws sit into the wood, I could fill them and paint to get a completely smooth finish but I like how it looks for now.
Only drill this hole half way into the wood, then get a bit the same size as your wall screw and drill the hole right the way through. Position the fittings where you want them and mark the wall through these holes so that you have the correct position. Then use the appropriate wall fitting to attach them securely to the wall.
Once they are up you can add your choice of pendant or lamp shade. These ones were $9.99 each from Bunnings and perfect for my white on white scheme.
You could go out and buy one of those pretty colourful pendant cords and use them in this project, but there are two problems. First they are pendants and don't have a plug fitting which means you are going to have to attach one yourself. The second is that the flex cord may be to short for your project remember to measure what you need. If you want to use a colour flex contact an electrical specialist store and they will be able to get them for you.
So I am delighted with the project. I can't wait to do another project soon. Planning planning!
Thanks to Worx tools for letting me test drive the brushless motor drill. I really love it and you can read all about why in the previous post. As always all opinions are entirely my own.